Maintenance of pneumatic rust remover:

1. The air supply to the tool must be treated to ensure clean and dry.

2. Please use an oiler to lubricate the tool, and adjust the flow rate to 3-4 drops per minute. If you do not use an oiler, you need to inject 3-4 drops of lubricating oil from the pipe joint every day. Please use our company's lubricating oil for lubricating oil. Please idling after oil injection, so as to facilitate the partial lubrication of the oil and use the discharged oil to carry some impurities.

Note: Please do not use oil or grease with high viscosity instead, which will cause abnormal rotation of the tool or even damage.

Air tool parts are precision machined piece by piece, so throwing, dropping or rough handling is strictly prohibited.