Connect the pneumatic tool to the air production line and set the air pressure. The air production line must be equipped with an air lubricating oil device. If the air lubricating oil device is unqualified or not available, the following daily maintenance should be performed for the tool. After 3 to 4 hours of continuous work, Separate the tool from the air source, drop 7-8 drops of high-purity light oil with low viscosity from the air inlet of the tool, connect the air pipe, open the air source, and blow the oil into the cylinder.

For qualified users of the pneumatic rust remover and the working strength is relatively full, it is recommended to install a small oiler at the intake joint. Usually 30-40 days, the air compressor and oil-water separator need to be regularly drained and maintained to remove impurities to ensure that the air entering the pneumatic rust remover is clean and dry.